![]() ![]() ![]() The 3.3v supply is for low-current use only. If you are using ESCs with BECs then remove the center RED wire from all but one ESC connector. ![]() POWER OFF before unplugging, plugging in or making any connections.Ĭonnect only one SOURCE of power to the VCC pins / Do not connect more than one source of power to two or more of the VCC pins. Go to FeatureAcro: Standard model for racing/acro flying QWinOut Acro 6DOF Version Pro SP Racing F3 Flight Controller NAZE32 Upgraded for DIY 250 RC Racer Quadcopter FPV Drone I2C port always powered, perfect for external sensors or always-on OLED Screen.īuzzer port for audible warnings and notifications. Sonar support for precision low-altitude hold. Programmable LEDĭedicated output for programmable LEDs - great for orientation, racing and night flying.īattery monitoring ports for voltage and current. Supports SBus, SumH, SumD, Spektrum1024/2048, XBus, PPM, PWM receivers.No external inverters required (built-in). The SPRacingF3 has an ARM Cortex-M4 72Mhz CPU with Math co-processor (FPU) for efficient flight calculations that gets more done in less time.Loop times up to ~2x as fast as previous-generation STM32F1 based boards.ĭeveloper friendly debugging port (SWD) and boot mode selection, unbrickable bootloader.įull support for OneShot ESCs for easy PID tuning and a sharper response On-board high-capacity black box flight log recorder - optimize your tuning and see the results of your setup without guesswork. The SPRacingF3 has a standard 36x36mm form-factor with 30.5mm mounting holes and weighs just 6 grams. ![]() The SPRacingF3 runs Cleanflight which can be configured to suit your needs using a cross-platform GUI (Windows/OSX/Linux). Connect your OSD + SmartPort + SBus + GPS + LED Strip + Battery Monitoring + Sonar + 8 motors - all at the same time. Many more features such as RGB LED strip support, Autotune, In-flight PID tuning with your radio, blackbox flight data logging etc.īetter coding practices and introducing tests, easier to maintain and for future development.(Dominic has software development background).Additional PID controllers that uses floating point arithmetic operations.(now has 3 built-in PID Controllers) DescriptionĪcro Version: Standard model for racing/ acro flying No-Compromise I/O Supports OneShot ESC and more than 8 RC channels.Supports more flight controllers, including CC3D, CJMCU and Sparky. SP Racing F3 Flight Controller Acro 6 DOF for RC Multicopter for DIY Mini 180 190 195 210 220 250 280 300 330 RC Drone. Go to FeatureThe hardware was designed by the lead developer of Cleanflight to be more capable than the previous-generation STM32F1-based boards after hearing feedback from the Cleanflight users, contributors and top-pilots. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |